Niciun produs
lcd35raspberrytouch
Produs nou
Ecran display 3.5" LCD cu touch screen pentru Raspberry PI2 PI3 model b / b+
Ultimul articol in stoc
Data disponibilitate
Ecran display 3.5" cu touch screen pentru Raspberry PI2 PI3 model b / b+ cu rezolutie de 480x320 pixeli și touchscreen.
| LCD Type | TFT |
|---|---|
| LCD Interface | SPI |
| Touch Screen Type | Resistive |
| Touch Screen Controller | XPT2046 |
| Colors | 65536 |
| Backlight | LED |
| Resolution | 320*480 (Pixel) |
| Aspect Ratio | 2:3 |
| Power Consumption | TBD |
| Backlight Current | TBD |
| Operating Temp. (℃) | TBD |
| PIN NO. | SYMBOL | DESCRIPTION |
|---|---|---|
| 1, 17 | 3.3V | Power positive (3.3V power input) |
| 2, 4 | 5V | Power positive (5V power input) |
| 3, 5, 7, 8, 10, 12, 13, 15, 16 | NC | NC |
| 6, 9, 14, 20, 25 | GND | Ground |
| 11 | TP_IRQ | Touch Panel interrupt, low level while the Touch Panel detects touching |
| 18 | LCD_RS | Instruction/Data Register selection |
| 19 | LCD_SI / TP_SI | SPI data input of LCD/Touch Panel |
| 21 | TP_SO | SPI data output of Touch Panel |
| 22 | RST | Reset |
| 23 | LCD_SCK / TP_SCK | SPI clock of LCD/Touch Panel |
| 24 | LCD_CS | LCD chip selection, low active |
| 26 | TP_CS | Touch Panel chip selection, low active |
Pentru a instala LCD-ul descarcați scriptul de instalare și dați următoarele comenzi:
chmod +x setup.sh
sudo ./setup.sh
Pentru a activa touchscreen-ul verificați ca in /boot/config.txt să fie scris "dtparam=spi=on" și adăugați linia următoare:
dtoverlay=ads7846,cs=1,penirq=17,speed=500000,swapxy=0,pmax=255,xohms=100,xmin=200,xmax=3900,ymin=200,ymax=3900,keep_vref_on=1
SURSA EXTERNA: https://github.com/notro/fbtft/wiki
Nu sunt opinii ale clienților în acest moment.
Senzor presiune MAP MPS20N0040D-D0-40kPa DIP-6
17,00 lei
Placa dezvoltare STM8S STM8S105K4T6
31,00 lei
Shield nRF24L01 (2.4 GHz) wireless transmitator...
14,00 lei
Set radiatoare aluminiu pentru Raspberry Pi 2...
14,00 lei
Senzor temperatura rezistent la apa DS18B20
21,00 lei